No need to seek help from a professional plumber
Unclogging a toilet with adhesive tape is an affordable and straightforward method you can perform at home without the need for professional assistance.
Tips for Unclogging a Toilet with Tape
The principle behind this method is to use water pressure to push the clogging waste down the drainage system. Adhesive tape creates a tight seal over the toilet bowl, generating strong pressure when flushing. This simple yet surprisingly effective method can resolve clogs. Here's what you'll need:
A roll of wide adhesive tape (commonly used for sealing boxes) to cover the toilet bowl completely.
Rubber gloves to maintain hygiene during the process.
A clean cloth or towel to wipe the toilet bowl before applying the tape.
Instructions:
Prepare the Surface:
Use a clean cloth or towel to thoroughly dry the area around the toilet bowl rim. This ensures the adhesive tape sticks securely and does not peel off during the process.
Apply the Tape:
Stick strips of tape across the toilet bowl, ensuring the entire opening is sealed. Overlap the strips slightly to eliminate any gaps. Make sure the bowl is completely covered with a tight layer of tape.
Seal the Tape:
Put on rubber gloves and gently press down on the tape to secure the seal. Be careful not to press too hard, as this could damage the tape.
Flush the Toilet:
Flush the toilet gently. As water fills the bowl, the tape will bulge upward due to the water pressure. This pressure should push the clogging material down the drain.
Remove the Tape and Check:
After flushing, carefully remove the tape and check if the toilet is unclogged. If the blockage persists, you can repeat the process.
Important Notes:
Handle the process gently to avoid damaging the toilet or causing any accidents.
Ensure the tape is applied tightly to achieve the desired pressure effect.
This DIY technique offers a simple and effective solution to common toilet clogs while saving you the cost of professional services.
